Hoping to hook up with my HP Tuners connection so we can get the PCM set up! Still have to wire the fan connections to my harness though. Also, all ends of the connections were flared so my hoses DO NOT blow off under pressure.Īnd the installed pic. Yes, That is the F-Body heater hose lines I cut down and installed on the frame rail. Heater valve new home and you can see the "T" I made to connect to the Euro Expansion Tank. After that we can wrap it up and set it on the ground and go from there.įew more pics from this weekend and for the 5 secs we got to hear it run the exhaust sounds AMAZING!Ĭustom heater hose "T" I made since I couldn't find the size I needed in something other than cheap plastic. Then we can fill it with coolant and let it break in. Still need to get in touch with my HP Tuners connection so we can turn off VATS and set up a few more things. Test fired right quick and it fired right up. We also had so many issues with the driver side and had to refabricate part of it and all 8 primaries are horribly bent right from the flanges which forced me to basically make a custom set of wires with 115* ends.Īnyways. I will eventually be ditching these and going a different route. The driver side header collector is very tight between the bell housing and the fuel filter heat shield. The driver side collector flange should've been extended a few more inches longer so it would end up beside the T56 case instead of next to the bell housing. DO NOT use Sikky LS Swap headers for anyone looking at doing this swap. They are a little close to the driver side header but everything else is close with these damn headers.
Thank you for the complements on the brake lines! I did my best to make them look like they were supposed to be there. See the pics from my first few posts on page one. I'm also running a Mishimoto radiator that I already had in the car. Way better the US piece of crap that the US cars got and yes it is self bleeding. Whenever I had to bend any, they always ended up looking like crap. I have no idea how people can bend those things and make them look like they came like that from the factory.
0 kommentar(er)
